 |
05-14-2009, 12:53 PM
|
#1 (permalink) |
|
Status: Member
Join Date: Nov 2008
Posts: 98
|
Error when using Set command in netsh.exe in Windows Server 2003
I am running Windows Server 2003. I am trying to change the properties of an IP address using “Set” command in netsh.exe, but I am getting the error message as “A device attached to the system is not functioning”. How do I fix this error? Please help me.
Thanks in advance. |
|
|
|
05-14-2009, 12:54 PM
|
#2 (permalink) |
|
Status: Senior Member
Join Date: Oct 2008
Posts: 907
|
Refer the below Microsoft KB article. Hope, it may help you.
"A Device Attached to the System is Not Functioning" Error Message When You Use the Set Command in Netsh.exe |
|
|
|
|
| Bookmarks |
| Tags |
| netsh command, netsh.exe, netshell tool, set command, windows server 2003 |
| Thread Tools | |
| Display Modes | |
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Error when running auditpol command in Windows Server 2008 | Bhupathi | Windows server/NT/Work Station | 1 | 05-08-2009 01:18 PM |
| Netsh commands for DHCP in Windows Server 2003 | Salokh | Network | 1 | 05-06-2009 07:05 AM |
| Error message when running the Adprep /rodcprep command in Windows Server 2008 | master | Windows server/NT/Work Station | 1 | 04-28-2009 07:38 AM |
| How to migrate the IPv6.exe commands to netsh command? | aarzoo | Network | 1 | 04-18-2009 06:58 AM |
| Using the Netsh Command to Manage Windows XP Firewall | Aptora | Operating systems | 0 | 11-26-2008 09:24 AM |
Linear Mode
